Connection To Peripherals - Motorola MVME6100 Installation And Use Manual

strap must be secured to your wrist and to ground throughout the
procedure.
2. Remove any filler panel that might fill that slot.
3. Install the top and bottom edge of the MVME6100 into the guides of
the chassis.
Warning Only use injector handles for board insertion to avoid
!
damage/deformation to the front panel and/or PCB. Deformation of
the front panel can cause an electrical short or other board
Warning
malfunction.
4. Ensure that the levers of the two injector/ejectors are in the outward
position.
5. Slide the MVME6100 into the chassis until resistance is felt.
6. Simultaneously move the injector/ejector levers in an inward direction.
7. Verify that the MVME6100 is properly seated and secure it to the
chassis using the two screws located adjacent to the injector/ejector
levers.
8. Connect the appropriate cables to the MVME6100.
To remove the board from the chassis, press the red locking tabs (IEEE
handles only) and reverse the procedure.

Connection to Peripherals

When the MVME6100 is installed in a chassis, you are ready to connect
peripherals and apply power to the board.
http://www.motorola.com/computer/literature
Connection to Peripherals
1-13
1