Flame Characteristics; Cleaning - Cannon FITZFS-SDSEB-NG User Instructions

Flame characteristics

The heater flames should be stable, not lifting from burner and the logs
should glow after approximately 15 minutes operation on HIGH setting.
The heater has been designed to burn with luminous flames, which mimic
natural log combustion, and may exhibit slight carbon deposition. If heavy
carbon deposits occurs or flames impinge on the roof of the combustion
chamber, turn the appliance off and contact the service agent in your state.
For service to this appliance refer page 19 for contact details.

Cleaning.

All cleaning should be carried out when the heater is cold. Normally the
heater should only need wiping with a lint - free damp cloth. Any stubborn
stains can be removed with a non-abrasive spray on cleaner. If an abrasive
cleaner is used the paint finish will be damaged.
For heater fitted with the glass front
All cleaning should be carried out when the heater is cold. Clean the outer
glass with a liquid solution such as 'Windex' or similar. Do not use harsh
abrasive cleaners or sharp metal scrapers to clean the heater glass front
since they can scratch the surface, which may result in shattering of the
glass.
Internally the heater should only be cleaned by a licensed service person
listed in this manual.
If your heater requires attention contact your supplier or licensed service
person listed in this manual.
Important:
The appliance should be inspected before use and at least annually by an
authorised service person. More frequent cleaning may be required due to
excessive lint build-up from carpeting, bedding materials, pet hair, etc.
It is imperative that control compartments and circulating air passage ways
of the appliance be kept clean.
Do not use this fire if the glass is cracked or with the glass safety screen
removed.
Do not use fire with broken or missing logs.
8