Table of Contents
Advertisement
Cleaning
All cleaning should be carried out when the heater is cold. Normally the
heater should only need wiping with a lint - free damp cloth. Any stubborn
stains can be removed with a non-abrasive spray on cleaner. If an abrasive
cleaner is used the paint finish will be damaged.
For heater fitted with the glass front:
All cleaning should be carried out when the heater is cold. Clean the outer
glass with a liquid solution 'Windex' or similar.
Do not use harsh abrasive cleaners or sharp metal scrapers to clean the
heater glass front since they can scratch the surface, which may result in
shattering of the glass.
Internally the heater should only be cleaned by an authorised service per-
son listed in this manual.
If your heater requires attention contact your supplier or authorised service
person listed in this manual.
Flame characteristics
The heater flame should be stable, no lifting from the burner and the logs
should glow after approximately 15 minutes operation on HIGH setting.
The heater is a fuel effect unit and is designed to operate with luminous
flames and may exhibit slight carbon deposit on the logs. If any excess
carbon build-up on logs, or the burner flame is unstable, contact Sampford
IXL in your state. (See phone contact no page 24).
Important:
The appliance should be inspected before use and at least annually by an
authorised service person. More frequent cleaning may be required due to
excessive lint build-up from carpeting, bedding materials, pet hair, etc.
It is imperative that control compartments, burners and circulating air pas-
sage ways of the appliance be kept clean.
Do not use this fire if the glass is cracked or with the glass safety screen
removed.
Do not use fire with broken or missing logs.
8
Advertisement
Table of Contents
