Gas connections
13. Slide heater into the fireplace ensuring that gas inlet pipe is fed through
the hole at the rear bottom RHS of the heater. Refer figure 24 and gas
connection figure 26.
-
24
14. With heater in position, flanges should be hard against masonry. Se-
cure case flanges to the masonry. Refer figure 25.
25
15. Connect incoming gas supply pipe to regulator. For inlet position see
figure 26. Close gate over gas supply and seal around the pipe with
fibreglass insulation material. Sealing is important as it prevents leak-
age from fan chamber into chimney: also check for gas soundness.
26
15