Table of Contents
Advertisement
15
6. Prepare electrical and gas connections. A 10 Amp wall socket needs
to be located within 1.5m of the heater. If using a power point in the
chimney, route the plug and cord through cord access at lower LH
side of rear panel.
A grommet is fitted over the cord. Ensure that the grommet is located
over the edges of the access hole. Refer figure 15.
Hard (fixed) wiring connection is to be carried out only by a qualified
electrician.
7. Remove the lower front cover by unscrewing two M5 screws from the
air intake slot. Refer figure 16. If unit is fitted with supply flexible cord
ensure that the cord cannot be trapped when the heater is installed.
Note: if the flexible cord is damaged, disconnect from supply socket.
Remove the damaged flex and replace with spare-part assembly
F2799.
16
8. Remove two s/t screws from bottom flange of front panel as indicated
on figure 17.
17
9. Disconnect the switch loom connector from the loom plug.
Refer figure 18.
18
13
Advertisement
Table of Contents
