Table of Contents
Advertisement
14
you gently to partly disengage it from the body of the heater. After it has
been disengaged gently lift it up vertically to completely disengage it
from the body of the heater. Refer figure 19 & 20.
19
11. Remove the inner glass. Slacken off
screws in top clamp and remove side
clamps. Refer figure 21.
Sealing
12. All gaps between heater case and
fireplace are to be sealed. Seal with
foam tape around top and sides of
heater flange as required. Refer fig-
ure 22.
Seal with fibreglass between bot-
tom of heater case and base of
fireplace.
If using a spacer to
compensate for lack
of chimney depth en-
sure the tape is
placed on the outer
rim of the spacer
flange. Refer figure
23.
23
20
21
22
Advertisement
Table of Contents
