Operations Common To Each Mode - Clarion CMD6 Owner's Manual

Operations Common to Each Mode

To change adjustment setting
1. Press the [ADJUST] button to switch to
the adjustment selection display.
2. Press the [X] or [V] button to select the
"item name".
"CLOCK" ↔ "CONTRAST" ↔
"SETTINGS" ↔ "SCROLL" ↔
"DIMMER" ↔ "TEL-SP" ↔ "TEL-SW" ↔
"RESET" ↔ "SYSTEM CHECK"
3. Turn the [UP/DOWN] knob to select the
"desired setting value".
In the case of display blinking "ENT", you
can press the [ ] button to adjust the
setting value.
4. After completing settings, press the
[ADJUST] or [RETURN] button to return to
the previous mode.
● Setting the clock
2-1. Select "CLOCK".
3-1. Press the [ENTER] button.
3-2. Press the [X] or [V] button to select the
hour or the minute.
3-3. Turn the [UP/DOWN] knob to set the
correct time.
The clock is displayed in 12-hour format.
3-4. Press the [ENTER] button to store the time
into memory.
Note:
• You cannot set the clock when it is displayed
with only the ignition on. If you drain or remove
the boat's battery or take out this unit, the clock is
reset. While setting the clock, if another button or
operation is selected, the clock set mode is
canceled.
● Setting the contrast
You can adjust the display contrast to match the
angle of installation of the unit.
The factory default setting is "9".
(Adjustment level: 1 to 10)
2-1. Select "CONTRAST".
3-1. Turn the [UP/DOWN] knob to adjust the
contrast.
● Displaying the settings
The number of indicator of this unit decreases,
you can see the state of current settings at any
operation mode.
2-1. Select "SETTINGS".
3-1. Turn the [UP/DOWN] knob to display the
state of current settings.
When the setting is selected, after 1 second
the current state will be displayed.
For example:
● Setting the method for title scroll
Set how to scroll in CD-TEXT, MP3/WMA/AAC
title.
The factory default setting is "ON".
2-1. Select "SCROLL".
3-1. Turn the [UP/DOWN] knob to select "ON"
or "OFF".
• ON:
To scroll automatically.
• OFF:
To scroll just 1 time.
When you want to see the title again, in the
title mode, press and hold the [DISPLAY]
button for 3 seconds or longer to scroll the
title.
● Setting the dimmer control
You can set the dimmer control "ON" or "OFF".
The factory default setting is "ON".
2-1. Select "DIMMER".
3-1. Turn the [UP/DOWN] knob to select "ON"
or "OFF".
● Setting the speaker output for cell
phones
When the rear AUX1 input terminals is used to
connect an AUX BLUETOOTH BB (BLT370)
(sold separately):
The factory default setting is "RIGHT".
To output the telephone calls, set cell phone
interrupt to "ON".
2-1. Select "TEL-SP".
3-1. Turn the [UP/DOWN] knob to select
"RIGHT" or "LEFT".
• RIGHT: Telephone calls can be heard on
the front right speaker connected to this
unit.
after 1 second,
23
CMD6