Clarion CMD6 Owner's Manual page 24

Operations Common to Each Mode
• LEFT: Telephone calls can be heard on
the front left speaker connected to this
unit.
● Cell phone interrupt setting
If you connect this unit and your cell phone with
an optional cable, you can listen to your calls on
your speakers.
When the rear AUX1 input terminals is used to
connect an AUX BLUETOOTH BB (BLT370)
(sold separately):
The factory default setting is "OFF".
2-1. Select "TEL-SW".
3-1. Turn the [UP/DOWN] knob to select
setting. When turning the [UP/DOWN]
knob, the setting changes as follows:
"OFF" ↔ "ON" ↔ "MUTE"
• OFF: This unit continues normal
operation even when the cell phone is
used.
• ON: Telephone calls can be heard from
the speakers connected to the unit.
When listening to calls on your speakers,
turn the [VOLUME] knob to adjust the
volume.
• MUTE:
The sound from this unit is muted
during telephone calls.
Note:
• If connecting a hands-free kit, make sure the
setting is ON to receive telephone audio through
the system.
● Performing memory reset
This function allows you to reset adjusted
settings in the ROM.
The stored settings like preset channels,
password adjusted areas, adjust mode settings
and audio mode settings can be formatted by
this function.
Note:
• The settings will remain in the ROM even if you
turn the power off or press the reset button.
2-1. Select "RESET".
3-1. Press and hold the [ENTER] button.
This unit will be restarted automatically.
24
CMD6
● Performing a system check
This function allows you to perform a system
check from the adjust mode when required.
2-1. Select "SYSTEM CHECK".
3-1. Press and hold the [ENTER] button
(1 sec.).
"SYSTEM CHECK" appears in the display,
then the unit returns to the previous
operation mode.
AUX function
The rear AUX terminals of this system is
provided to allow playback of sounds and music
from external devices connected to this unit.
● Selecting AUX mode
1. Press the [AUX/iPod] button to select
"AUX 1" or "AUX 2".
● Selecting AUX IN sensitivity
Make the following settings to select the
sensitivity when sounds from external devices
connected to this unit are difficult to hear even
after adjusting the volume.
The factory default setting is "MID".
1. Press the [OPTION] button.
2. "AUX SENS" appears in the display.
3. Turn the [UP/DOWN] knob to select "HIGH",
"MID" or "LOW".
Note:
• When AUX mode is selected, AUX IN sensitivity
can be set.