Parental Lock Function; Scan Function - Clarion CMD6 Owner's Manual

SIRIUS Satellite Radio Operations
Receiving stations selected by
category
Satellite Radio allows you to select broadcast
channel category (contents).
1. Press and hold the [SAT] button (1 sec.) to
select the category selection mode.
It press and hold once again, return to the
channel selection mode.
2. Turn the [UP/DOWN] knob to change the
category item.
3. Press the [X] or [V] button to tune a
channel in the current category.
4. If press and hold the [X] or [V] button, it will
quick tune a channel in the current category.
5. If turn the [UP/DOWN] knob, it will tune the
first channel in the next or last category.
Notes:
• When the category selection mode is
entered, the category of the last received
channel is displayed first.
• If no operation is perfomed whin 10 seconds,
the category selection mode is canceled,
and resumes to the channel mode.

Scan function

There are two scan modes: the category scan
mode and the preset scan mode.
During scanning channels are displayed in
abbreviated form, the display mode cannot be
switched.
● Preset scan (PRESET SCN)
A preset scan scans the channels (up to
18 channels) stored in the preset memory about
every 10 seconds.
This function is available in the channel selection
mode.
1. Press the [OPTION] button.
2. Press the [X] or [V] button to select
"PRESET SCN".
3. Press the [ENTER] button.
And start the preset scanning.
● Category scan (CAT SCN)
In a category scan, broadcast channels in the
same category as the current channel are
selected about every 10 seconds.
This function is available in the category selection
mode.
1. Press the [OPTION] button.
18
CMD6
2. Press the [X] or [V] button to select "CAT
SCN".
3. Press the [ENTER] button.
And start the category scanning.
Note:
• Category scanning is not available when no
category is defined for the current channel.

Parental Lock function

This fuction allows you to set a listening
limitation level.
This setting is possible only when a password is
entered.
● Setting the Password
The factory default setting is "0000".
1. Press the [OPTION] button.
2. Press the [X] or [V] button to select
"PARENTAL PASSWORD".
3. Press the [ENTER] button.
4. Input the old password.
4-1.Press the [X] or [V] button to move the
cursor.
4-2.Turn the [UP/DOWN] knob to select a
number.
4-3.Press and hold the [ENTER] button.
5. Input a new password.
Repeat step 4-1 to 4-3.
6. Input the new password again.
Repeat step 4-1 to 4-3.
Note:
• If you forget the password, you can do the
following operations:
Input the old and new password with "4356",
and it will return to the factory default setting
"0000".
Input the old password with "4356", and then
operate step 5-6.
● Locking Channel
1. Select a desired channel.
2. Press the [OPTION] button.
3. Press the [X] or [V] button to select "LOCK
CH".
4. Press the [ENTER] button.
5. Input the right password.
5-1.Press the [X] or [V] button to move the
cursor.
5-2.Turn the [UP/DOWN] knob to select a
number.
6. Press and hold the [ENTER] button.