Clarion CMD6 Owner's Manual page 26

USB/MTP Operations
• Do not turn on the engine when the MTP
device is connected, since it may result in
loss or damage to data on the MTP device.
Connect the MTP device to the USB cable
after the engine is turned on.
Connecting a USB memory/MTP
device
1. Connect the USB memory/MTP device to the
USB cable.
Playback will begin from the first file
recorded on the device.
If the device is not recognized, press the
[AUX/iPod] button to switch the source to the
device.
Always insert the device fully into the
connector. Incomplete connections may
cause the device not to be recognized.
Depending on the number of tracks recorded,
some amount of time may be required until all
tracks are read into the unit.
The order in which tracks are recorded may
differ depending on the device connected (the
actual playback order may not be the same as
that indicated on your computer's display).
26
CMD6
To listen to tracks on a connected
USB memory/MTP device
1. Press the [AUX/iPod] button to switch the
source. When USB memory/MTP device is
selected, playback (except DRM files) will
begin from the location at which playback
was previously stopped.
When a USB memory/MTP device is
connected the USB/MTP mode will be
displayed.
When a USB memory/MTP device is
disconnected and then reconnected, playback
will begin from the previous position of the
USB memory/MTP device.
When "MTP" mode is selected, AAC files on
the MTP device cannot be played.
To stop play
1. Press the [DISC], [AUX/iPod] or [SAT]
button and switch the function to a source
other than the USB memory.
CAUTION
Do not remove the USB memory/MTP device
when the USB/MTP mode is selected, since it
may result in loss or damage to data on the
USB memory/MTP device.
Always backup and save important data on
your computer.
2. Remove the USB memory/MTP device from
the USB cable.