Operations; Basic Operation - Clarion GR10BT Owner's Manual & Installation Manual

6. OPERATIONS

Basic Operation

CAUTION
When the unit is turned on, starting and
stopping the engine with its volume raised to
the maximum level may cause hearing damage.
Be careful about adjusting the volume.
Power On/Off
Note:
- Start the engine before using this unit.
- Be careful about using this unit for a long time
without running the engine. If you drain the
vessel battery too far, you may not be able to
start the engine and this can reduce the service
life of the battery.
1. Start the engine.
Engine ON
position
2. Press the [ / SRC ] button to turn on the power
under standby mode. Press and hold to turn off
the power.
At power on mode, press to toggle source
among Tuner, USB, BT Music, AUX.
* External equipment not connected to this unit
is not displayed.
Adjusting the volume
Press [ VOL + / VOL- ] button to increase or
decrease the volume.
The adjustable range of volume is 0 to 40.
CAUTION
While boating, keep the volume at a level at which
external sounds can still be heard.
Please be aware of the volume levels in residential,
family areas and local volume level ordinances.
6
Adjusting the volume
Press and hold [BAND] button to enter
sound effect setting mode. Press [
] button to select options, press [VOL + ]
[
or [VOL -] to adjust a value / option.
* EQ (Preset Equalizer Setting)
Press [VOL + ] or [VOL -] to change EQ:
Flat -> Pop -> Classic -> Rock -> Techno ->
Vocal -> Jazz.
*Bass
Press [VOL + ] or [VOL -] to adjust the desired
Bass level range from -7 to +7.
* Mid
Press [VOL + ] or [VOL -] to adjust the desired
Mid level range from -7 to +7.
* Treble
Press [VOL + ] or [VOL -] to adjust the desired
Treble level range from -7 to +7.
* Balance
Press [VOL + ] or [VOL -] to adjust the Balance
between the right and left speakers from R12
(full right) to L12 (full left).
* Fader
Press [VOL + ] or [VOL -] to adjust the Fader
between the front and rear speakers from
R12(full rear) to F12 (full front).
* Tone
Press [VOL + ] or [VOL -] to select tone on/off.
* Area
Press [VOL + ] or [VOL -] to select between
USA, Europe, Asia, Australia.
* Rear out
Press [VOL + ] or [VOL -] to select Line out or
Subwoofer out.
(Note: with Line out selected, following option
will not be displayed.)
* Subw LPF
Press [VOL + ] or [VOL -] to adjust
the sub-woofer Low Pass Filter range:
80HZ/120HZ/180HZ.
* Subw On/Off
Press [VOL + ] or [VOL -] to select subwoofer
on or off.
* Subw Gain
Press [VOL + ] or [VOL -] to adjust subwoofer
gain range: 0 to 20.
] or