Clarion CMD6 Owner's Manual page 14

Basic Operations
●
Setting the BBE MP
(Sound Enhancement and
Restoration for compressed audio
files)
BBE MP (Minimized Polynomial Non-Linear
Saturation) Process improves digitally
compressed sound, such as MP3, by restoring
and enhancing the harmonics lost through
compression. BBE MP works by regenerating
harmonics from the source material, effectively
recovering warmth, detail and nuance.
This fuction is effective for the audio files in the
CD/MP3/WMA/AAC or USB/iPod mode.
2-1. Select "BBE MP".
3-1. Turn the [UP/DOWN] knob to select "ON"
or "OFF".
The factory default setting is "OFF".
3-2. When you select "ON", press the [ENTER]
button, then turn the [UP/DOWN] knob to
select as following order.
LOW l MID l HIGH
Notes:
• Manufactured under license from BBE Sound,
Inc.
• Licensed by BBE Sound, Inc. under one or more
of the following US patents: 5510752, 5736897.
BBE and BBE symbol are registered trademarks
of BBE Sound, Inc.
● Adjusting the bass
2-1. Select "BASS".
Turn the [UP/DOWN] knob to adjust the gain
from –7 to +7 (The factory default setting is "0").
● Adjusting the treble
2-1. Select "TREBLE".
Turn the [UP/DOWN] knob to adjust the gain
from –6 to +6 (The factory default setting is "0").
14
CMD6
● Adjusting the balance
2-1. Select "BALANCE".
3-1. Turn the [UP/DOWN] knob to adjust the
balance of the right and left speakers.
The factory default setting is "CENTER"
(center). (Adjustment range: RIGHT12 to
LEFT12 (right 12 to left 12))
● Adjusting the fader
2-1. Select "FADER".
3-1. Turn the [UP/DOWN] knob to adjust the
balance of the rear and front speakers.
The factory default setting is "CENTER"
(center). (Adjustment range: FRONT12 to
REAR12 (front 12 to rear 12))
● Adjusting the non-fader volume
Adjust volume output from the unit's non-fader
output terminal.
2-1. Select "NO FADER".
3-1. Turn the [UP/DOWN] knob clockwise to
increase volume; turn counterclockwise to
decrease volume.
The factory default setting is "0".
(Adjustment range: +6 to –6)
• During SOUND adjustment mode, if no operation
is performed for more than 10 seconds, this
mode can be cancelled and return to previous
mode.