Oce Arizona 350 User Manual page 26

14. Tape the media onto the core. The media should have a clean straight
edge prior to taping. First tape the center of the media to the core, and then
tape both ends of the media.
15. Select the Initialize icon from the Roll Media Manager to properly tension
the media and to prepare for printing.
16. From the Roll Media Manager select the media to be printed on or create
a new set of media parameters for the media loaded.
Unloading of media follows a similar procedure using the Roll Manager on the
Controller.
Copyright © 2008 BERTL, Inc.
All Rights Reserved. The license under which this document is made available and applicable law prohibit any reproduction or further transmission of any portion of this document. This
document may only be viewed electronically through the www.BERTL.com Web site and may not be stored in electronic or hard copy format. Any reproduction of trademarks is strictly
prohibited. BERTL accepts no responsibility for any inaccuracies or omissions contained in this document.
WideFormat
March 8, 2009
Océ Arizona 350 GT Printer
www.bertl.com
WHAT WE LIKED
•
Unloading and loading of media rolls
is relative easy even though it's a 16-
step procedure.
•
The Roll Media Option accepts a wide
range of paper types, from standard
bond, vellum, translucent bond, film,
and gloss.
WHAT WE WOULD LIKE TO SEE
•
The load and unload media procedure
could be more automated.
March 8, 2009
Page 26