4.3 Calibrate the EFI controller
Check the measurement options and click 'Measure'.
2.
[43] Measurement button
Check the spectrometer and click 'OK'.
3.
[44] Spectrometer ready?
Follow the instructions in the EFI Spectrometer window precisely.
4.
Perform the following actions per colour.
Position the spectrometer at the blinking red cross above the column with coloured
patches.
Hold down the spectrometer button and wait for the beep.
Scan the column with patches slowly.
[45] Measurement instructions
Click 'OK'.
5.
[46] Measurement successful?
Apply the calibration.
6.
Check 'Apply to all calibration sets' to use this calibration for all media.
42
Chapter 4 - Printer calibration