Main Steps In Calibration - Oce CS550 Pro User Manual

Main steps in calibration

Main steps in calibration
#
Main step
1. Check the print quality
Continue only if the colour reference chart does not meet your requirements.
2. Calibrate the controller
The result of the controller calibration as checked in 3.2 normally meets the required
print quality. If the print quality still does not meet your requirements, you can
consider to proceed with the printer calibration.
3. Calibrate the printer
Note:
1
Calibration of your copy process only requires step 4.1 and 4.2.
Note:
2
Calibration of the printer requires calibration of the controller because the controller
takes the printer settings into account at controller calibration.
8 Chapter 1 - Introduction
Sub-step
'2.0 Check the print quality' on page 10
'3.1 Calibrate the EFI controller' on page 12
or
'3.1 Calibrate the Creo controller' on page 17
or
'3.1 Calibrate the Océ PRISMAsync controller' on page
20
'3.2 Check the print quality' on page 28
'4.1 Perform the adjustment operation' on page 30
'4.2 Adjust the white point (gamma offset)' on page 33
1
'4.3 Calibrate the EFI controller' on page 39
or
'4.3 Calibrate the Creo controller' on page 44
or
'4.3 Calibrate the Océ PRISMAsync controller' on page
2
47
'4.4 Check the print quality' on page 55
1
2
2