Table of Contents
Advertisement
4.3 Calibrate the EFI controller
Introduction
The external controller is either an EFI (IC303/IC305/IC408), a Creo (IC304/IC304Plus)
or an Océ PRISMAsync controller. This procedure describes the calibration of the EFI
controller. In case of an IC408 controller you must use CWS on a remote PC. Before
you can calibrate the EFI controller you must print the calibration chart.
Print the calibration chart
From 'Command Workstation', click 'Server' - 'Manage color...'.
1.
Click 'Calibrator'.
2.
[37] Calibrator button
Select or check the measurement method.
3.
[38] Measurement method selection list
4.3 Calibrate the EFI controller
Chapter 4 - Printer calibration
39
Advertisement
Table of Contents
