Table of Contents
Advertisement
3.1 Calibrate the Creo controller
Introduction
The external controller is either an EFI (IC303/IC305/IC408), a Creo (IC304/IC304Plus)
or an Océ PRISMAsync controller. This procedure describes the calibration of the Creo
controller. At the beginning of the procedure you print a calibration chart that is used to
calibrate the Creo controller.
Calibrate the Creo controller
Click 'Tools' - 'Calibration'.
1.
The 'Color Calibration' window opens.
Print the calibration chart.
2.
At 'Tray', select the location of the media you use mostly.
At 'Media Type:', define the media you use mostly.
At 'Screening:', define the screening you use.
The default is 'Dot1'
At 'Number of copies:', select 5.
Use the last print to calibrate.
Click 'Print'
The printer performs an automatic calibration adjustment and makes the prints.
[13] Calibration chart settings
3.1 Calibrate the Creo controller
Chapter 3 - Controller calibration
17
Advertisement
Table of Contents
