Fujitsu fi-5900C Operator's Manual page 46

⇒ The stacker will be fixed in a horizontal position.
HINT
ATTENTION
<Changing Stacker table motion>
Thin paper sometimes curles when it is ejected to the stacker. This method may be effective to improve the
stacking capability by fixing the stacker hight in the appropriate position.
1. IF the device driver of the scanner is active on PC monitor, close it.
2. Press both Hopper Height buttons on operator panel (
more than 2 seconds.
⇒ Every time this is done, the stacker table moves between the lowest position and the
position little a bit above. Set the stacker table at the position little a bit above the lowest
position.
26
2.7 Setting up the Stacker
• When set to the "bottom edge alignment" position, the stacker will auto-
matically adjust its height according to its load.
• When set to the "Bottom edge alignment" position, the stacker's maxi-
mum load will be 500 sheets.
• On both sides walls of the stacker, photo sensors are installed to detect
document height on the stacker. Make sure these sensors are not
blocked.
• The stacker may move up or down when the scanner is in the ready
status up or when scanning starts. Do not touch the stacker or place
anything on it at those times.
Photo sensors
and ) for