Fujitsu fi-5900C Operator's Manual page 201

Item
Page edge filler
Fill the end sections of a specified-mm-wide
(ADF) with white or black on the scanned image.
"Section 8.6" When the backing (background) color is
white, the end sections are filed with white;
and when the background color is black,
filled with black.
Dropout Color Drop out a preselected color for the scanned
"Section 8.7" image. (Binary black & white/grayscale
mode only)
Pre-Pick To give a higher priority to processing
"Section 8.8" speed, select [Yes], if not, select [No].
Page edge filler Fill the end sections of a specified-mm-wide
(Automatic paper
with white when the paper size is automati-
size detection)
cally detected.
"Section 8.9" The end sections of a specified-mm-wide are
filled with white.
Document check
• Selected range: This is checked to make
area specifica-
following checking area specification
tion for Multifeed
effective.
Detection
• Enable/Disable: Specifies whether left/
"Section 8.4"
middle/right each ultrasonic sensor is
enabled or disabled.
• Start: The start point of the check area in
length (mm) from top edge of the docu-
ment is specified.
• End: The end point of the check area in
length (mm) from top edge of the docu-
ment is specified.
Explanation Selectable parameter
Top/left/right: 0-15mm
Bottom: -7 to 7mm (can be set
in increments of 1mm)
A
B
(A: Image area B: Filled area
A+B: Area to be output)
Red/Green/Blue/None
Yes/No
Top/Left/Right/Bottom: 0 to
7.5mm (can be set in incre-
ments of 0.5mm)
A
B
(A: Image area B: Filled
area
A+B: Area to be output)
• Selected range
• Enable/Disable
• 0 to 510 mm, with 2 mm
increment
• 0 to 510 mm, with 2 mm
increment
8.1 Scanner Settings
Default
Top/Bottom/
Left/Right:
0mm
8
Green
Yes
Top/Bottom/
Left/Right:
0mm
• Not
checked
• Invalid
• 0 mm
• 0 mm
181