2.0 Installation
Surface Mounting
The remote control can be mounted on the surface of a wall by using
the mounting ring.
Note: The mounting ring has a tabs at the top and bottom
that are made with a thinner material. This allows these tabs
to be cut or broken out to allow the communication cable to
be routed up or down the wall.
1.
Using the mounting ring as a template, mark on the wall the
location of the four mounting screws.
2. Drill appropriate sized holes (depending on the screws that will be
used - these are not supplied) in the four screw locations that were
marked.
3. Determine if the communication cable is running up or down the
wall and cut/break the appropriate tab on the mounting ring.
4.
Pull the cable through the mounting ring and place the ring with the
removed tab over the communication cable against the wall.
5. Position the mounting ring over the drilled holes and screw the
mounting ring to the wall
6. Connect the communications cable - routed thru the mounting ring
opening - to the RJ11 connector on the rear of the remote display
6. Secure the remote display to the mounting ring with the 2 Phillips
screws provided.
7. After ensuring the inverter is off; route the communications cable
exiting from the mounting ring into the REMOTE port on the front of
the inverter.
Mounting Ring
breakable tab
(allows cable to
be inserted)
Communication Cable
(routed down the wall)
4
Figure 4, Surface Mounting
screws x4
(not supplied)
BULK
INVERT
ABSORB
AC IN
ON/OFF
FAULT
FLOAT
©2006 Magnum Energy Inc.