Table of Contents
Advertisement
SUPERSERVER SYS-6026TT-H6RF/H6IBXRF/H6IBQRF User's Manual
Unpacking
The serverboard is shipped in antistatic packaging to avoid electrostatic discharge.
When unpacking the board, make sure the person handling it is static protected.
5-2
Serverboard Installation
T h i s s e c t i o n e x p l a i n s t h e f i r s t s t e p o f p h y s i c a l l y m o u n t i n g t h e
X8DTT-HEF+/HIBXF+/HIBQF+ into the SC827HQ-R1400B chassis. Following the
steps in the order given will eliminate the most common problems encountered in
such an installation. To remove the serverboard, follow the procedure in reverse
order.
Accessing the Inside of the System
1.
Remove all four screws securing the top cover of the chassis: two at the top
rear of the cover and one on each side lip, also near the back.
2.
Place both thumbs in the indentations and push the cover back until it slides
off.
3.
Lift the top cover from the chassis to gain full access to the inside of the
server. (If already installed in a rack, grasp the two handles on either side and
pull the unit straight out until the rails lock into place. See Figure 2-4.)
Check Compatibility of Serverboard Ports and I/O Shield
1.
The X8DTT-HEF+/HIBXF+/HIBQF+ in a Twin 1U confi guration requires the
use of Supermicro's 1U Twin chassis: the SC827HQ-R1400B.
2.
Make sure that the I/O ports on the serverboards align properly with their
respective holes in the I/O shield at the back of the chassis when installing.
Mounting the Serverboard onto the Serverboard Tray
1.
Carefully mount the serverboards by aligning the board holes with the raised
metal standoffs that are visible in the chassis.
2.
Insert screws into all the mounting holes on your serverboards that line up
with the standoffs and tighten until snug (if you screw them in too tight, you
might strip the threads).
3.
Metal screws provide an electrical contact to the serverboard ground to
provide a continuous ground for the system.
5-2
Advertisement
Table of Contents
