Changing Parameter Values With A Security Code In Use - Baldor 15H SERIES 15H Installation & Operating Manual

Section 1
General Information

Changing Parameter Values with a Security Code in Use

Action
Apply Power Keypad Display shows this
opening message.
If no faults and programmed for
LOCAL operation.
Press PROG key Enter program mode.
Press Y or B key
Scroll to Input block.
Press ENTER key Access Input block to change
Operating Mode setting.
Press ENTER key When security on, parameter
values cannot be changed.
Press B key
Enter the Access Code .
Example: 8999.
Press ENTER key
Press Y or B key
Scroll to make your selection.
Press ENTER Save selected parameter
Press Y or B key
Scroll to Menu Exit.
Press ENTER key Returns to Input block.
Press DISP key Return to Display mode.
4-10 Programming & Operation
Description
Note: Please record your access code and store it in a safe place. If you cannot
gain entry into parameter values to change a protected parameter, please
contact Baldor. Be prepared to give the 5 digit code located on the lower right
side of the Keypad Display at the Enter Code prompt.
Display
Logo display for 5 seconds.
Display mode. Stop LED on.
L: shows parameter is Locked.
V
represents blinking cursor.
P: will change to L: after you
return to Display mode for longer
than the time specified in the
Access Time parameter.
Typical display mode.
Comments
MN715