Section 1
General Information
Changing Parameter Values when Security Code Not Used
Action
Apply Power
Keypad Display shows this
opening message.
If no faults and programmed for
LOCAL operation.
Press PROG key
Access programming mode.
Press Y or B key
Scroll to Level 1 Input Block.
Press ENTER key
Access Input Block.
Press ENTER key
Access Operating Mode.
Press Y key
Scroll to make your selection.
Press ENTER
Save selection to memory.
Press Y key
Scroll to menu exit.
Press ENTER key
Return to Input Block.
Press DISP key
Return to Display Mode.
4-4 Programming & Operation
Use the following procedure to program or change a parameter already programmed into
the control when a security code is not being used.
Description
Display
Logo display for 5 seconds.
Display mode. Stop LED on.
Press ENTER to access INPUT
block parameter.
Keypad mode shown is the
factory setting.
Keypad mode shown is the
factory setting.
At the flashing cursor, select
mode desired. Standard run is
shown.
Press ENTER to save selection.
Typical display mode.
Comments
MN715