Setting Your Own Area Code; Setting The Base's Ip Address In Lan - Siemens Gigaset DL500A User Manual

Configuring the system settings

Setting your own area code

To transfer phone numbers (e.g., in vCards),
it is essential that your area code (interna-
tional and local area code) is saved on the
base.
Some of these numbers are already preset.
¢ ¢
Ï Settings
v
¢
Area Codes
Check that the (pre)set area code is correct.
¤
You can enter data as follows:
q
Select/change input field.
r
Navigate in the input field.
Ñ
If necessary, delete number:
Press the display key.
~
Enter number.
§Save§
Press the display key.
Example:
Area Codes
International code:
00 - 30
Local area code:
0 - [ ]
Info
Please note
It is especially necessary to set the inter-
national code if you connect a GSM
mobile to the base via Bluetooth. Phone
numbers transferred from the GSM net-
work always include the international
access code, even for calls within a coun-
try.
If, for example, you later wish to call back
the caller from a call list via one of your
phone's connections, the international
code is withheld for national phone calls.
92
Telephony
Save
Setting the base's IP address
in LAN
Prerequisite: Your base is connected to a
¢
router or a PC ( page
An IP address is required in order for the LAN
to "recognise" your base.
The IP address can be assigned to the base
automatically (by the router) or manually.
u
If done dynamically, the router's DHCP
server automatically assigns an IP
address to the base. The base's IP address
can be changed according to router set-
tings.
u
If done manually/statically, you assign a
static IP address to the base. This may be
necessary depending on your network
configuration (e.g., if your base is con-
nected directly to a PC).
You can also make local network settings via
the Web configurator.
Please note
To assign the IP address dynamically, the
DHCP server on the router must be acti-
vated. Please also read the user guide for
your router.
¢ ¢
v Ï Settings
¢
Local Network
~
Enter the current system PIN if
necessary and press
¤
You can enter data in the following fields:
IP Address Type
Select Static or Dynamic.
For IP Address Type Dynamic:
The following fields show the current set-
tings that the phone obtained from the
router. These settings cannot be
changed.
For IP Address Type Static:
You must manually define the IP address
and the subnet mask for the base in the
following fields, as well as the standard
gateway and DNS server.
15).
System
§OK§
.