Changing The Name Of An Internal Party; Changing The Internal Number Of An Internal Party - Siemens Gigaset DL500A User Manual

Connecting/using other devices
u
Speak to both participants at the same
time:
¤
Press the display key
the conference call. Press the display
§EndConf§
key to return to call swap
mode.
Ending an internal call
& / T
Replace the receiver or press the
red end key.
The external call is signalled as an incoming
call on the base. You can accept the call
¢
( page 27).
Internal call waiting during an
internal/external call
If an internal participant attempts to call you
while you are involved in an external or
internal call, this call is shown on the display
(internal call waiting). You can either accept
or reject this call.
Press any key to make this prompt disappear
from the display.
You must end the current call to accept the
internal call. Then the internal call is sig-
nalled as per usual. You can accept the call.
Changing the name of an
internal party
The names "INT 2", "INT 3" etc. are assigned
automatically at registration. You can
change these names. The name must be no
more than 10 characters. The modified name
will then appear in the list of internal partici-
pants.
u
Open list of internal partici-
pants.
s
Select handset.
§Options§
Open menu.
Rename
~
Enter/edit name.
§Save§
Press the display key.
76
§Conf.§
to establish
Changing the internal
number of an internal party
The base is assigned the internal number
INT 1 as a default setting.
A handset is automatically assigned the
lowest free internal number from 2–7 during
registration. If all numbers are in use, then
the number 7 is overwritten as long as this
handset is in idle status. You can change the
internal number of the base and all regis-
tered handsets (1–7).
u
Open the list of internal parties.
Your own device is marked
with < .
§Options§
Open menu.
Assign Handset No.
Select and press
s
Select the internal party.
r
Select a new number.
s r
Repeat the process for other
internal parties as required.
Make sure you do not assign an internal
number (1 to 7) twice.
To finish:
§Save§
Press the display key to save the
entry.
You will hear the error tone if an internal
number has been assigned twice.
¤
Repeat the procedure with a free number.
§OK§
.