Activating/Deactivating Call Screening; Setting The Recording Parameters - Siemens Gigaset DL500A User Manual

Hide thumbs Also See for Gigaset DL500A:
Table of Contents

Advertisement

Activating/deactivating call
screening
While recording a message, you can screen a
call via the base speaker or registered hand-
sets.
Permanently activating/deactivating
call screening
¢
¢
v
Ì
Call Screening
Desktop Phone
Select to activate/deactivate
call screening on the base
(³= on).
Handset
Select to activate/deactivate
call screening on the registered
handsets (³= on).
§Change§
Select display key to activate/
deactivate the function.
Deactivating call screening for the
current recording
You can deactivate the function during the
recording.
On the base:
§Silence§
Press the display key.
Answering a call
d / c Press the handsfree key or pick
up the receiver.
Operating the base's answering machine
Setting the recording
parameters
The answering machine has already been
preset at the factory. You can adjust individ-
ual settings via the base or a registered
handset.
¢
¢
Ì
v
Recordings
¤
You can enter data in the following fields:
Length:
Select maximum recording length 1 Min.,
2 Min., 3 Min. or Maximum.
Quality:
Select Excellent or Long Play recording
quality. If the quality is higher, the maxi-
mum recording time is reduced.
Ring Delay:
Select when the answering machine
should accept a call: Immediately, after
10 sec., 18 sec., 30 sec. or Automatic.
§Save§
Press the display key.
Information about ring delay
In Automatic mode, the following applies
for ring delay:
u
If there are no new messages, the answer-
ing machine answers a call after
18 seconds.
u
If new messages are present, the answer-
ing machine answers a call after 10 sec-
onds.
When operating remotely
you can tell after approx. 15 seconds that
there are no new messages (otherwise the
answering machine would have already
accepted your call). There are no call charges
if you hang up now.
Please note:
You can configure your telephone so that
the first ringer is suppressed on all calls
(page
53). This means that the time set for
the ring delay predetermines how long the
caller must wait before the answering
machine accepts the call (not how long it
rings).
¢
(
page
66),
65

Advertisement

Table of Contents
loading

Table of Contents