Connecting/Using Other Devices; Registering Handsets - Siemens Gigaset DL500A User Manual

Connecting/using other
devices
You can upgrade your base to a "PABX" by
connecting other communication devices.
You can register up to six handsets and six
Gigaset repeaters to your base.
Each registered device is assigned an inter-
nal number (2–7) and an internal name
(INT 2–INT 7). You can change the number
assignment and names.
If all internal numbers have already been
assigned on your base, you must deregister
a handset that is no longer required before
registering a new one.
You can also connect six Bluetooth devices
(one headset and a total of five GSM
mobiles/data devices,

Registering handsets

You must register a handset on the base (1)
and on the handset itself (2).
1. On the base:
To set the base to registration mode:
¢ Ï ¢
v
Registration
¢
Register Handset
The base's DECT interface is (assuming it is
deactivated) automatically activated as
soon as you set the base to registration
mode.
You can register the handset as long as the
display on the base shows the message
Please register your handset.
¢
page 77).

Connecting/using other devices

2. On the handset:
Within approx. 60 seconds.
¤
Start the registration procedure on the
handset in accordance with the hand-
set's user guide.
You are asked to enter the current system
PIN of the base on your handset (default
setting: 0000).
~
Enter the current system PIN
and press
After registering successfully
Handset registered is shown on the base's
display.
Please note
If six handsets are already registered to the
base (the internal numbers 2–7 are already
assigned), you have two options:
u
The handset assigned the internal
number 7 is in idle status:
The handset that previously had the
number 7 is deregistered; the new hand-
set is registered and is assigned the
internal number 7.
u
The handset assigned the internal
number 7 is in use:
The handset to be registered cannot be
registered. A message to this effect is
displayed on the handset.
Assigning the internal number
The base assigns the lowest free internal
number to the handset (possible numbers:
2–7). The internal number is shown on the
handset display e.g., INT 2. This means that
the handset has been assigned the internal
number 2. The base is assigned the internal
number 1.
§OK§
.
73