Using A Handset As A Room Monitor - Siemens Gigaset S645 Operating Instructions Manual

Using a handset as a
room monitor
If the room monitor mode is switched on,
the stored destination number is called as
soon as the noise in the room reaches a
defined level. You can save an internal or
external number in your handset as a des-
tination number.
The room monitor call to an external
number stops after approx. 90 seconds.
The room monitor call to an internal
number (handset) stops after approx. 3
minutes (depending on the base station).
All keys except the end call key are locked
during room monitoring. The handset
loudspeaker is muted.
In the room monitor mode incoming calls
are signalled on the handset without
ringtone and only shown in the display.
The display and keys are not illuminated
and advisory tones are also turned off.
When you answer an incoming call, the
room monitor mode is interrupted for the
duration of the call, the function remains
activated.
Room monitoring ends when you switch
off the handset. You have to reactivate the
function after switching on the handset.
Note:
– You should always check the operation
of the room monitor before use. Test the
sensitivity for example. Check the con-
nection when you divert the room moni-
toring to an external number.
– The active room monitor function consider-
ably reduces the operating time of the
handset. Place the handset in the charging
cradle if necessary. This ensures that the
battery does not discharge.
– Ideally the handset should be positioned 1
to 2 metres away from the baby. The micro-
phone must be directed towards the baby.
– The connection to which the room monitor
is diverted must not be blocked by an acti-
vated answering machine.

Using a handset as a room monitor

Activating the room monitor and
entering the number to be called
¢ ¢
v í
Room Monitor
¤
Changing a multiple line input:
Room M.:
Select On to activate.
Call to:
Press the display key
destination number.
External number: Select the number
from the directory or enter it directly.
Only the last 4 digits are displayed.
Internal number:
handset or Call All, if all registered
handsets are to be called)
Save the number with
Entry .
§OK§
Level:
Set the sensitivity for the noise level
(Low or High).
¤
Save changes (page 12).
The function is now activated. You can
change directly to the settings with v.
Changing the set external destination
number
¢ ¢
v í
Room Monitor
s
Scroll to
Press the display key.
§Edit§
X
Delete the available number.
¤
Enter the number as described under
"Activating the room monitor and
entering the number to be called"
(page 47).
¤
Save changes (page 12).
and enter the
§Edit§
s (select the
§INT§
.
§OK§
© Save
Call to:.
47