Text Input On The Handset - Siemens Gigaset S645 Operating Instructions Manual

Table of Contents

Advertisement

Text input on the handset

The following rules apply when writing a
text:
Control the cursor with u v t s.
u
u
Characters are inserted on the left of
the cursor.
Press the star key * briefly to
u
change from mode "Abc" to "123" and
from "123" to "abc" and from "abc" to
"Abc" (upper case: write the 1st letter in
upper case, all the others in lower
case). Press the star key * before
entering the letter.
Press the star key * and hold:
u
Shows the selection line of the charac-
ters assigned to the star key.
u
The first letter of the name of directory
entries is automatically capitalised, fol-
lowed by lower case letters.
Writing a text message/name
(without predictive text)
When you press a key and hold down, the
characters of the corresponding key are
displayed in the bottom display line and
marked one after another. When you
release the key the highlighted character
is inserted into the input field.
You can see in the display whether upper
case, lower case or digits are selected:
u
In the entry in the directory "A" or "a" is
in the bottom display line.
u
"Abc", "abc" or "123" is in the top right
of the display when entering a text
message.
Appendix
Writing a text message
(with predictive text)
EATONI predictive text helps you when
you are writing text messages.
Each key between Q and O is
assigned several letters and characters
(see the character set tables, page 68).
These appear in a selection line directly
below the text field (above the display
keys) as soon as you press a key. The letter
you are most likely looking for is reverse
highlighted and is at the beginning of the
selection line. It is copied into the text
panel.
1
Ç
470(2)
Abc
Hello Peter, I cannot come
2
today. Ic
hgi
W
¨
3
1 EATONI is switched on
2 Text of the message
3 Selection line
If this letter is the one you want, confirm it
by pressing the next key. If it does not
match the one you want, press the hash
key # short until the letter you are looking
for is reverse highlighted in the display
line and then transferred to the text field.
If you press the hash key # long the
selection line of the characters is displayed
which is assigned to the hash key.
Deactivating/activating predictive text
Requirement: You are writing a text mes-
sage.
©
Press the display key.
Predictive Text
Select and press
(‰ = on).
§OK§
a
Press the end call key short to
return to the text field. Enter
the text.
Page 67

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents