Resetting The Navigation System; Soft Reset; Switching The Device Off Completely/Hard Reset - Medion P4410 Operating Instructions Manual

Resetting the navigation system

Choose this option if your navigation system is not responding or working properly.
This option restarts the navigation system, without reinstallation being necessary. A
soft-reset is often used in order to reorganize the memory. In doing so all programs
that are running are interrupted and the working memory is reinitialized.

Soft Reset

Perform the soft-reset as follows:
Press the tip of the stylus into the soft-reset switch opening or
Insert a pointy object (e.g. a paper clip, which has been bent open) with slight
pressure into the reset opening.

Switching the Device off Completely/Hard Reset

Attention
A hard reset will delete all data in the temporary memory.
Your navigation system will normally be in the Standby Mode, if you have switched
it off by pressing the on/off button briefly. In addition, the system can be switched
off completely; the consumption of energy can be kept as low as possible through
this. All the data in the temporary memory will be lost if the device is switched off
completely (hard reset).
Switch your navigation system off completely in this way:
•
Press the on/off button for 6 seconds.
The device will be switched on again by pressing the on/off button again for
approx. 6 seconds.
The software will not have to be installed again, if your device has already been
furnished with the basic data of the navigation software in the permanent memory
in the factory.
Resetting the navigation system
17