Table of Contents
Advertisement
Alternative Installation of the Navigation Software
from a Memory Card
The software for your navigation system can also be installed directly from a mem-
ory card.
The pre-installed software may have to be uninstalled beforehand (see special
CleanUp function, Page 43).
You will be requested to install the navigation software during the initial adjust-
ment. Please proceed as follows:
1. Remove the memory card from the packaging carefully. Pay attention that
the contacts are not touched or soiled.
2. Push the memory card into the SD-/MMC slot until it engages.
3. Click on OK, in order to install the application.
The main screen, through which you will now be able to carry out the navigation
settings, will appear after all data has been copied to your navigation system.
Transferring Installation Files and Map Material to the
Internal Memory
Note
The navigation system must be connected to a computer by means
of ActiveSync
Your device has an internal, permanent memory, which is located in the \My Flash
Disk directory.
You will be able to make this directory, and others, visible with ActiveSync
means of the Search option. Directories and files can be manipulated as in Win-
dows Explorer.
The required directory must have been stored, in order to make the installation files
and the map material for the device available.
Deposit the INSTALL directory for the installation files at (\My Flash Disk\INSTALL).
Deposit the map material in the MapRegions directory (\My Flash
Disk\MapRegions). Please pay attention to the modes of lettering given above
when naming the directories.
Pay attention to the fact that sufficient drive capacity must be available, if you have
stored additional data on your navigation device. Remove files not needed if suffi-
cient drive capacity is not available.
52
®
(see Page 46), for the transfer of the data.
English
®
, by
- Quick Links:
- IV. Installing the Navigation Software
Hide quick links:
Advertisement
Table of Contents
