Iv. Starting The Navigation Software - Medion P4410 Operating Instructions Manual

IV. Starting the Navigation Software

Note
Your memory card will always have to be inserted into the device
during the use of the navigation system, if the card contains (addi-
tional) mapping material.
It will be necessary to carry out a reset to restart the navigation sys-
tem if the memory card has been removed while the system was be-
ing used (see page 17).
1.
Switch on your navigation system.
2.
The Navigation software will start automatically or after tapping on the
navigation control button on the main screen, according to the version.
3.
Tap on Navigation on the screen for entering the destination and enter the
address of your navigation destination. Confirm your entry by clicking the
symbol to start the navigation. You will receive the route information on the
screen, augmented by language statements, after a short time, if the satellite
reception is adequate.
Further information regarding the navigation software can be found in the com-
prehensive manual on your CD/DVD. This is a pdf-file you can read and print
with the any Acrobat Reader.
Note
The GPS-receiver will require some minutes for initialization when
deployed for the first time. Even when GPS signal reception is indi-
cated the navigation could be imprecise. In all future instances it will
take about 30-60 seconds until a correct GPS-signal is available, suffi-
cient "sight" of the satellite is a prerequisite.
Navigation
23