Resetting The Navigation System; Soft Reset; Switching The Device Off Completely / Hard Reset - Medion Navigation Unit Operating Instructions Manual

Resetting the Navigation System

You can reset your navigation system if it is no longer reacting or working properly.
This option restarts the navigation system, without reinstallation being necessary. A reset is
often used in order to reorganize the memory. In doing so all programs that are running
are interrupted and the working memory is reinitialized.
You can carry out two different Reset procedures with your device.

Soft Reset

The following screen will appear if you press the On/Off switch for a short time:
If you want to carry out a Reset, tap on
You will find further information in the chapter "Switching on/off the device", page 15.

Switching the Device off Completely / Hard Reset

Attention!
A hard reset will delete all data in the temporary memory.
Your navigation system will normally be in the Standby Mode, if you have switched it off
by pressing the on/off button briefly. In addition, the system can be switched off com-
pletely; the consumption of energy can be kept as low as possible through this. All the
data in the temporary memory will be lost if the device is switched off completely (hard reset).
To switch your navigation system off completely:
1. Press and hold the On/Off key (> 3 sec.), to switch off the device.
2. Press and hold the On/Off key (> 3 sec.), to switch the device on again.
A reinstallation will be necessary after a hard reset if your device has already been
equipped with the basic data of the navigation software in the permanent memory at the
factory.
UK/ N. IRELAND HELPLINE 0871 37 61 020
REP. IRELAND HELPLINE 1-800-992508
.
- 22 -