Table of Contents
Advertisement
8. Resetting the Navigation System
You can reset your navigation system if it is no longer reacting or working properly.
This option restarts the navigation system, without reinstallation being necessary. A
reset is often used in order to reorganise the memory. In doing so all programs that
are running are interrupted and the working memory is reinitialised.
You can carry out two different Reset procedures with your device.
8.1. Reset
The following screen will appear if you press the On/Off switch for a short time:
If you want to carry out a Reset, tap on
.
You will find further information in the chapter on "6.1. Switching on/off the Device",
page
20.
8.2. Switching the Device off Completely / Hard Reset
ATTENION!
A hard reset will delete all data in the temporary memory.
Your navigation system will normally be in the Standby Mode, if you have switched
it off by pressing the on/off button briefly. In addition, the system can be switched
off completely; the consumption of energy can be kept as low as possible through
this. All the data in the temporary memory will be lost if the device is switched off
completely (hard reset). To switch your navigation system off completely:
Press and hold the On/Off key (approx 3 sec.), to switch off the device.
Press and hold the On/Off key (approx. 1 sec.), to switch the device on again.
A reinstallation will not be necessary after a hard reset if your device has already
been equipped with the basic data of the navigation software in the permanent
memory.
27 of 82
Advertisement
Table of Contents
