Controls
Opening and closing
E
To close: press and hold the upper
section of switch 1 on the centre con-
sole or the switch in doorway 3.
The indicator lamp in the switch
flashes. The sliding door closes and
you will hear a signal.
E
Release switch 2 on the centre con-
sole or the switch in doorway 3 once
3
the sliding door has reached the de-
sired position.
The sliding door stops moving.
i
The indicator lamp in the centre console
lights up when the vehicle is stationary or while
the vehicle is in motion if the sliding door is
open.
Opening/closing using the key
1 D To open/close the sliding door
70
E
To open: press button 1 for longer
than 0.5 seconds.
The sliding door unlocks and opens or
the sliding door closes.
E
To close: press button 1 again.
The sliding door stops moving.
If the vehicle is equipped with two electric
sliding doors, it is only possible to program
the remote control to one of the sliding
doors. You can program the remote con-
trol in both keys independently.
1 Switch for sliding door on left-hand
side
2 Switch for sliding door on right-hand
side
E
To program the key: insert the key in-
to the ignition lock.
Nur fuer internen Gebrauch
E
Make sure that the doors are closed.
E
Switch on the ignition.
E
Press switch 1 or 2 for the desired
door for approximately 5 seconds.
The indicator lamp in the switch
flashes. A signal sounds three times as
confirmation. You can use the remote
control to operate the sliding door se-
lected above.
Anti-entrapment feature
G
Risk of injury
The anti-entrapment protection function
does not eliminate the possibility of fingers
or other parts of the body being trapped
against the door frame and therefore does
not eliminate the risk of injury.
Always make sure that nobody is present
within the operating range of the sliding
door.
If the electric sliding door is obstructed
during opening, the sliding door moves a
few centimetres in the opposite direction
and stops.
If the electric sliding door is obstructed
during closing, it reopens completely.
Need help?
Do you have a question about the Vito and is the answer not in the manual?