3.1.7 Connecting a serial cable for downloading software
(Please see inside cover Figure 10)
Connect the RS 232 connector on the back of your receiver to the Serial port of
your computer using a serial cable.
4.0 Starting up
Ensure that your terrestrial receiver is correctly connected to your television and dish, and
that your antenna signal is of good quality. (If you are not sure about this then ask your
local Strong dealer to check your installation or antenna signal).
4.1 Starting up for the First Time
Connect your DVB-T receiver as described under one of the points in
paragraph 3.
Press "MENU" key (13);
Using the arrow up or down keys (5), move the cursor until the highlight colour
is over INSTALLATION; Press the SELECT key (7).
Using the arrow up or down keys (5), move the cursor until the highlight colour
is over CHANNELS SETUP; Press the SELECT key (7).
To select AUTOMATIC tuning, press the RED function key (18).
Wait a few minutes while the tuning automatically finds and loads all the
channels.When tuning has completed, press the BACK key (11)
to view the picture.
14