Strong SRT 5855 User Manual page 21

TV/VCR Settings: You can set the TV/VCR settings to your personal preferences.
Check your TV and VCR user manuals for the correct settings. You can change
your TV/VCR settings by applying the following steps:
1. Select "TV/VCR Settings" and press SELECT or the Right button.
TV Mode: Press SELECT or the Right button and set your TV
mode to "Multi", "PAL" or "NTSC".
Video Mode: Press SELECT or the Right button and set your VCR
mode to "CVBS" (Composite video) or "RGB" (preferred option if
your TV set is compatible with it).
Screen Mode: Press SELECT or the Right button and set your
screen mode to "4:3 Full Screen", "4:3 Letter" or "16:9".
Audio Output: Press SELECT or the Right button and set your
audio output to "Stereo", "Left only" or "Right only" (left or Right
is for mono TV sets)
S/PDIF Output: Press SELECT or the Right button and activate
your S/PDIF output on the back of your receiver, so you can
connect it to a digital Audio amplifier using a coaxial cable.
Antenna power (ON/ OFF). Antenna Power is preset in OFF
Mode. Only when using an active antenna this function must be
switched "ON". Press SELECT or the Right button to select
"ON".
UHF Mode: Press SELECT or the Right button and set the UHF
mode to "PAL B/G", "PAL I" or "PAL D/K". If the TV set is
connected using a coaxial (RF) cable, you must select
RF modulator type here. The RF modulator type affects
the channel audio. (Select PAL I for UK, NI or ROI use.)
VCR Scart: Press SELECT or the Right button and set the
scart output to "Auto" or "STB" (Set Top Box). If set to
"STB", the VCR scart signal is not automatically looped
through.
19