Connection For Cp180/Cp180I - Standard Horizon CP300I Owner's Manual

NMEA ACC 2 Cable
Pin Wire Color Description
1 Black NC
2 Red NC
3 Green NMEA Common
4 Blue Port 4 Input
5 Brown Port 4 Output
6 Gray Port 5 Input
7 White Port 5 Output
8 Yellow NC
**NOTE: AIS RECEIVER OPTION
When an optional AIS rceiver is connected, Port 4 of the NMEA in/out Communication setup
menu must be changed to AIS 38400 as shown below for communications.
1. From the Chart page, press [MENU]. Move the ShuttlePoint knob to highlight SETUP
MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight ADVANCED SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight IN/OUT CONNECTIONS and press [ENT] or
move the ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to highlight PORT 4 INPUT and press [ENT] or move the
ShuttlePoint knob to the right.
5. Move the ShuttlePoint knob up/down to select AIS 38400 and press [ENT] or move the
ShuttlePoint knob to the right.
6. Press [CLR] or move the ShuttlePoint knob to the left until the Chart page is shown.
Video Connector
Pin Description
1 Ground
2 + 9 / 12 VDC
3 Video Signal +
2.4.2

Connection For CP180/CP180i

2.4.2.1 DC Power Connection
Page 18
Connection Example
Common (ground) for NMEA devices
Connect to Output of NMEA device
Connect to Input of NMEA device
Connect to Output of NMEA device
Connect to Input of NMEA device
Connection Example
Connect to Video Signal Ground of DVD/VCR/Video Cameras
Connect to Video Cameras Power Input
Connect to NTSC Video Signal + of DVD/VCR/Video Cameras
Additional Comments
Default is NMEA0183**
Default is NMEA0183 with GLL, RMB, RMC
and XTE sentences
Default is NMEA0183
Default is NMEA0183 with GLL, RMB, RMC
and XTE sentences
GPS Chart Plotters