Flush Mounting The Antenna - Standard Horizon CP300I Owner's Manual

Choose a location for the antenna that has a clear view of the sky and is not located within
3 FT of Radar or other transmitting antennas. Ensure there are no major obstructions or
fixtures in the immediate proximity to the antenna. The antenna relies on direct "line of sight"
satellite reception. If you are unsure of the chosen location, temporarily mount the antenna
in the desired location to verify correct operation. If mounted close to Radar, after the GPS
Chart Plotter has a fix, turn on the Radar to ensure the GPS Chart Plotter holds the fix (use
the GPS Status Page).
The thread used on the antenna is an industry standard (1inch 14TPI) used on a wide range
of mounting brackets. Due to the manufacturing process of these mounting brackets, the
antenna may not tighten all the way down onto all the threads. This is no concern however
as the antenna must be tightened until the antenna stops rotating.
The antenna cable can be cut and spliced to ease installation. Care must be taken when
reconnecting the antenna cable to protect from water and corrosion.
2.3.0

Flush mounting the antenna

Before drilling holes, it is recommended the antenna be positioned where the location is planned,
cable connected to the GPS Chart Plotter and power turned on to ensure a GPS Fix is received.
1. Remove the threaded base from the antenna dome.
2. To ease installation a flush mounting template for the antenna has been included.
3. Apply the mounting template sticker to the area that was verified for GPS reception.
4. Then, drill out the 0.63" (16mm) and 0.16" (4mm) holes, and remove the template.
5. Insert the cable into the 0.63" (16mm) hole and route to the GPS Chart Plotter.
6. Apply a small amount or RTV to the under side of the antenna.
7. Place the antenna and then screw it into place using the screws.
In some cases the screw may not be long enough, if this happens simply apply more RTV to the
underside of the antenna to glue it into place.
GPS Chart Plotters
NOTE
NOTE
NOTE
Figure 2.3.0 - Installing the GPS WAAS Smart Antenna (I)
CUTTING TEMPLATE
0
16 mm [0.63"] or greater
0
4 mm [0.155"]
Figure 2.3.0a - Installing the GPS WAAS Smart Antenna (II)
0
4 mm [0.155"]
0
4 mm [0.155"]
GPS OVERALL SHAPE
Page 15