Standard Horizon CP300I Owner's Manual page 17
Color gps chart plotters
Hide thumbs
Also See for CP300I:
- Owner's manual (131 pages) ,
- Installation and operation manual (45 pages) ,
- Operation manual (32 pages)
Table of Contents
Advertisement
2.4.2.2 Connection of the FF520, AIS receiver, VHF and Autopilot
Port 2 input and output is used by the optional FF520. In the diagram above you will notice Port 2
Input and Output wires are shown in gray and not used.
AIS Setup
The CP180 or CP180i has to be setup to be able to receive NMEA information from the AIS
receiver.
1. Press [Menu], move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight ADVANCED SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight IN/OUT CONNECTIONS and press [ENT] or
move the ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to highlight PORT 1 INPUT and press [ENT] or move the
ShuttlePoint knob to the right.
5. Move the ShuttlePoint knob up/down to select AIS 38400 and press [ENT] or move the
ShuttlePoint knob to the right.
GPS Chart Plotters
NOTE
Page 19
Hide quick links:
Advertisement
Table of Contents
