SSANGYONG STAVIC 2006 Owner's Manual page 56

1. MIST 2. OFF
The wiper operates once when Stop the operation.
pushing up the lever. The lever
will return to the "OFF" position
when released.
AUTO Position Recognition
Function
When you start the engine with the wiper
switch "AUTO" position, the wiper will op-
erate once to remind you that the wiper
switch is in "AUTO" position.
CAUTION
• Auto position recognition, especially in winter, may reduce the life span
of the wiper blade. Make sure the wiper switch is at "OFF" position
unless it rains.
• During winter time, the wiper blade can be frozen to windshield. Wiper
operation while blade is frozen can damage wiper motor. Be sure to
check the blade before operation.
4 - 8
INTERIOR SWITCHES
3. AUTO
Operates automatically ac-
cording to the vehicle speed or
amount of rain.
Rain Sensing Wiper
This sensor detects the amount of rain while
the wiper switch is in "AUTO" position. If the
rains become heavier, the speed of the wip-
ers gets faster and smaller, the speed reduces.
CAUTION
• The wiper operation on dry wind- shield can scratch glass and wear
the blade prematurely. Do not operate wiper when the windshield is
dry.
• When you clean the windshield over the sensor with damp cloth, the
wiper may operate suddenly. It could cause serious injury. Make sure
to place the wiper switch and ignition switch to "OFF" position when
not in use.
• Make sure to place the wiper switch to "OFF" position before wash-
ing the vehicle.
4. LO/HI
LO: Continuous wipe, slow operation
HI: Continuous wipe, fast operation
5. Wiper and Washer Coupled
Operation
Pull the lever briefly (below 0.6 seconds):
One wiping cycle without washer spray
Pull and hold the lever for more than 0.
6 seconds: Three wiping cycles with
washer spray
6. Automatic Wiping Speed
Control Switch
The interval of wiper swings can be ad-
justed by twisting the control knob up-
ward or downward when the windshield
wiper switch is in AUTO position.
F : Fast interval
S : Slow interval