Changing The Battery - Silvercrest CRE-521 Instructions Manual

18.2

Changing the battery

To change the battery, please press the lock on the left side of the battery case slightly to
the right. Now the battery compartment can be pulled out towards the front.
Now replace the old battery with a new one of the same type (CR 2025). Please pay
attention to the polarity ("+ pole" to the top) when you insert the battery. Please only touch
the battery on the edge, since there might be contact problems otherwise.
Now slide the battery compartment with the new battery back into the case. Make sure that
the battery compartment snaps back into the case.
Note:
Please remove the safety disk on the battery compartment before first using the remote control. Otherwise the remote control
won't operate properly.
Disposal of the battery
Please consider that you as an end consumer are obligated to return discarded batteries to a distributor or a redemption site
intended for this purpose by a public waste management facility.
English
43