Silvercrest CRE-521 Instructions Manual page 47

Problem Cause
The connection cables haven't been
The device does not
attached correctly.
play any music
The "MUTE" or "pause" button is pressed.
On / off button was pressed too briefly.
The operating unit isn't inserted correctly.
The device can't be
The ignition is turned off.
turned on
The connection cables haven't been
attached correctly.
The fuse is blown.
The radio hasn't been connected correctly.
The device doesn't
The device temperature is too high.
retain the stored
stations Contacts 4 and 7 haven't been connected
properly or the vehicle manufacturer has
assigned these in reverse.
CD isn't being drawn The two safety screws were not removed,
in completely. or not entirely.
The CD was inserted with the printed side
to the bottom.
The CD has too many scratches.
The inserted CD
The CD is dirty.
can't be played.
The device temperature is too high.
The CD contains incorrect or faulty data.
Solution
Please check if all cables have been attached correctly.
Press the "MUTE" or "pause" button again.
Keep the on / off button pressed longer.
Reinsert the operating unit.
Turn on the ignition
Please check if all cables have been attached correctly.
Replace the fuse.
Please check if all cables have been attached correctly.
Reduce the volume of the device.
Remove the transparent plugs on the yellow and red
cable and plug them back together crosswise (yellow to
red and red to yellow).
Please remove the safety screws and try again.
Flip the CD over and try again.
Create another CD from the original or have the CD
repaired.
Clean the CD (without cleaning agents, just a lint-free
cloth).
Reduce the volume of the device.
The CD can't be used with this device. Please burn your
audio data onto a separate data storage medium and try
again.
English
47