Aux In; Settings; Menu Level - Silvercrest CRE-521 Instructions Manual

16 AUX IN

The AUX IN is a connection with which you can connect external audio devices through their headphone or AUX output with
this device. The audio tracks played back on these devices are then put out through the car speakers. This is how you can e.g.
play back audio files that you have saved on your mobile phone, minidisk, iPod
To connect external audio devices with the MP3/WMA/OGG car radio CRE-521, you will need a cable with a 2.5 mm jack plug
on a 3.5 mm jack plug, which is contained in the scope of the delivery. Connect this cable to the headphone connection or AUX
output of your playback device and begin the playback. Set the volume of the playback device to a medium level and
subsequently regulate the volume with your Silvercrest CRE-521. If the playback source of the Silvercrest CRE-521 has not
been set to AUX yet, please press the "MODE" button

17 Settings

17.1 Menu level 1

By briefly pressing the volume control dial
treble setting, and the speaker balance between the left and right as well as front and rear speaker groups can be selected and
set.
Changing the bass setting (BASS)
Pressing the control dial twice will result in reaching the bass settings. The message "BAS" will appear on the display together
with the current level (e.g. "+2"). To change the bass bandwidth, turn the control dial
bandwidth can be set in a range between "-7" and "+7". It can be changed in increments of one.
The setting is saved either when the desired value is confirmed by pressing the control dial
(don't change anything on the device for approx. five seconds). If you confirm the selection by pressing the control dial
will reach the next possible setting. If you use the automatic storage, the device will return to the standard display.
Changing the treble setting (TREBLE)
After pressing the control dial
the display together with the current level (e.g. "0"). To change the bandwidth of the treble, turn the control dial clockwise or
counter-clockwise. The bandwidth can be set in a range between "-7" and "+7". It can be changed in increments of one.
The setting is saved either when the desired value is confirmed by pressing the control dial
(don't change anything on the device for approx. five seconds). If you confirm the selection by pressing the control dial
will reach the next possible setting. If you use the automatic storage, the device will return to the standard display.
32
until AUX appears on the display.
once or several times, the functions of menu level 1, volume control, bass setting,
three times, the treble setting (TREBLE) can be reached. The message "TRE" will appear on
®
or tape recorder.
clockwise or counter-clockwise. The
or through automatic storage
or through automatic storage
, you
, you