Midas LEGEND 3000 Operator's Manual page 16

The PAN defaults to control the channel
placement within the master stereo mix
and has a constant power law. i.e. - 3dB
at the centre position.
The PAN switch changes all group bus
assignments to operate via the stereo pan
pot.
The SIS switch enables the spatial
imaging system which operates in
conjunction with the pan control to
produce a left, centre, right master mix.
The SOLO switch sends input monitor
channel signals to the MON PFL/AFL
busses and sends input front of house
channel signals to the FOH PFL/AFL
stereo busses. If the switch is pressed for
a short time it will latch on or off, but, if it
is held on for more than 1 second the
latching is disabled and when the switch
is released the channel solo will turn off.
As a default the solo system is auto
cancelling so each new solo cancels the
last. The SOLO ADD mode switch on
the master module defeats the auto
cancelling and allows multiple channel
monitoring. If the master module SOLO
SIS is enabled the front of house solo
buses will switch to LCR operation.
When the spatial imaging system is
active the IMAGE control can modify
the action of the pan control so as to
place the channel within a three speaker
system. When the image control is fully
clockwise the pan control will operate in
full left, centre, right such that a centre
panned signal will route to the centre
speaker only and will not appear in either
of the left or right outputs. When the
image control is fully anti-clockwise the
pan control reverts to stereo such that a
c
centre panned signal will route at equal
power to the left and right speakers. All
other Image control positions generate a
composite blend of the stereo and LCR
panning systems so that the optimum
pan
l r
degree of centre image focus and speaker
power can be obtained. When the image
control and pan control are both set
central the channel will be routed with
stereo lcr
equal power to all three speakers.
image
PAN MONO
The MONO switch connects the post
fader channel signal to the mono master
SIS ST
bus.
The ST switch connects the post fader
SOLO
channel signal to the master stereo bus
via the pan control.
6