Konica Minolta BIZHUB PRO 1050 User Manual page 483

Utility Tool
Configuring IP address to the network interface card
Regardless of the printing mode selected, the network interface card must
be given the IP address and routing parameters. You can configure the IP
address for the network interface card in one of the following ways:
- Use DHCP (Dynamic Host Configuration Protocol).
- Use arp and ping capability.
- Use BOOTP (Internet Boot Protocol).
- Use reverse ARP (rarp) capability (Ethernet II frame type only).
- Use arp command, MAP (Management Access Program), or BOOTP Lite
for Windows.
Note
You can use the BOOTP, rarp, or arp and ping procedures only when the
network interface card is in its default state (when no IP information has
been entered).
Depending on the topology, you may need to provide the MAC address of
the network interface card. The MAC address is the 12-character code that
is printed on the Status Page each time the print controller and the main body
printer is turned on.
After the network interface card has an IP address, you must use the MAP
utility, or other dedicated utilities (for Windows or Macintosh) to change an
IP address, Subnet Mask and Default Gateway.
bizhub PRO 1050/1050e/1050P/1050eP
11
11-41