Punching Holes In Copies (Punch Settings) - Konica Minolta BIZHUB 750 User Manual

3

Punching holes in copies (Punch settings)

!
Detail
In order for holes to be punched in the copies, all of the following condi-
tions must be met.
The paper width must be between 148 mm and 314mm.
The paper length must be between 210 mm and 420 mm.
If a Punch setting is to be selected, select the orientation in which the
document is positioned. If an Original Direction setting is not selected,
holes may not be punched in the copies as desired.
For details on specifying the document orientation, refer to "Selecting the
original orientation (Original Direction settings)" on page 3-24.
If a Punch setting is selected, specify the position of the binding margin
and the loading orientation for the original, otherwise the holes will not be
punched as desired.
For details on specifying the loading orientation for the original, refer to
"Selecting the original orientation (Original Direction settings)" on
page 3-24. For details on specifying the position of the binding margin for
the original, refer to "Selecting the position of the binding margin (Margin
settings)" on page 3-28.
Note
The number of punched holes differs depending on the country (region)
where the unit is installed. For details, consult your technical representa-
tive.
The number of holes that can be punched differs depending on the type
of punch kit installed. If different hole punch settings are available, select
the setting for the desired use.
The procedure for selecting two punched holes is described below.
When Finisher FS-504/FS-602 and Punch PK-504/PK-505 are installed is in-
stalled
Paper Weight
2
50g/m to 128g/ m
3-78
Paper Size
2
A3 w, B4 w, A4 w, A4 v, B5 w, B5 v, A5 w, A5 v, Foolscap
Basic copy operations
bizhub 750/600