Mobile Base Serial Connector; Configuring The Dolphin Terminal - Hand Held Products Dolphin 9550 User Manual

Mobile Base Serial Connector

The following diagram displays the pin diagram of the serial connector of the bottom panel of the Mobile Base.
Note: Signals referenced are for a DTE device.
The Mobile Base connector is straight to the printed circuit board (PCB). The ninth pin sends 500mA at 5V power out. This can
power a peripheral device, such as a mobile printer, as long as that peripheral device can accept 500mA at 5V.

Configuring the Dolphin Terminal

Communications Properties must be configured appropriately on the Dolphin 9500/9550 terminal for it to communicate with the
Mobile Base.
To set Communications Properties:
1. Tap Start > ActiveSync > Tools > Options.
2. Tap the PC Connection tab
3. Check the Enable Synchronization check box.
11 - 8 Dolphin® 9500/9550 Mobile Computer User's Guide