Advertisement
Available languages
Available languages
PRESS
AND KNITS
This washer
can hold up to a 16 [b (7 kg) load of laundry.
1.
PD Models:
Insert coins until "SEI.ECT CYCI.E" flashes in display.
PR Models:
A debit card is required
rather than coins.
In Enhanced
Debit
mode, the card
balance
win also display
when a debit card is inserted
into the reader.
2.
Door must be closed before cycle selection
is made,
3.
Press fabric
setting
keypad
for the wash cycle desired.
After the cycle is started,
the time
win
display and count
down.
4.
When
a cycle is interrupted
by opening
the doob
"RESEI.ECT CYCI.E"
win flash in the
display. To restart the washeb
close door and press any key.
....
INOPERATIVE
STAY[ - These lines on the display indicate
the appliance
is inoperative.
Enter setup mode to view @agnostic
code.
"0 MINUTES"
SHOWING
IN DISPI.AY - This condition
indicates
the appliance
cannot
be
operated.
Coins dropped
or debit inputs during
this condition
win be stored in escrow
but
cannot
be used until normal
operation
is restored by opening
and dosing
the door. If a door
switch
fails, it must be replaced
before normal
operation
can be restored.
COI.D
START (Initial first use) - Appliance
is programmed
at the factory
as follows:
Washer
14-minute
wash period
3 rinses (extra rinse not enabled)
$1.75 wash price (PD models)
$0.00 wash price (PR mode[)
WARM
START (after power failure)
- A few seconds
after power
is restored,
if a cycle was in
progress
at the time of the power
failure,
"RESEI_ECT CYCI.E" win flash in the display,
indicating
the need for a key press to restart washer.
DOOR
I_OCK - The door will be locked
when the cycle starts. The door will remain
locked
until the end of a cycle or approximately
2 minutes
after a power
interruption.
PRICING
- After the door is opened
following
the completion
of a cycle, the display
indicates
the cycle price (unless set for free operation).
As coins are dropped
or debit inputs arrive, the
display
will change to lead the user through
the initiation
of a cycle.
FREE CYCI.ES - This is established
by setting the cycle price to zero. When
this happens
"SEI.ECT CYCI.E" will appear rather than a cycle price.
DEBIT CARl)
READY - This appliance
is debit card "cable"
ready. It will accept
a variety
of
debit card systems, but does not come with
a debit card reader. Refer to the debit card reader
manufacturer
for proper
washer
setup. In models
converted
to a Generation
1 debit card
system, debit pulses represent
the equivalent
of one coin.
DISPLAY - After the washer
has been installed
and plugged
in, the display
will show
"0 MINUTES."
Once the washer
has been plugged
in and the washer
door opened
and closed
the display will
show the price.
In washers
set for free cycles the display will flash "SEI.ECT
CYCI.E."
12
Advertisement
