Table of Contents
Advertisement
Installing the Switch
The Ethernet switch can be installed in a standard EIA 19-inch rack or on a
table or desktop. The following instructions explain how to install the switch
as a stand-alone unit. For instructions on how to install the switch as part of a
stack, refer to the AT-8324SX Fast Ethernet Switch Installation Guide.To
install the switch, perform the following steps:
1.
Remove all components from the shipping package and store the
packaging material in a safe location.
2.
Locate a level, secure surface for the switch.
3.
If you purchased an expansion module for the switch, install the module by
following the instructions included with the module, or by referring to the
AT-8324SX Fast Ethernet Switch Installation Guide.
4.
If you purchased an AT-BSTACK1 Stacking Module or an AT-BMGMT
Management Module for the switch, install the module by following the
instructions included with the module or by referring to the AT-8324SX
Fast Ethernet Switch Installation Guide.
5.
Stick the supplied self-adhesive rubber feet to the four concave spaces
located in the corners on the bottom of the switch.
Do not install the self-adhesive feet if you are installing the switch
in a rack.
6.
To install the switch in a standard EIA 19-inch rack, do the following:
a. Using a cross-head screwdriver, attach the supplied brackets to the
sides of the switch.
b. Position the switch in the rack by lining up the holes in the brackets
with the appropriate holes in the rack.
c. Attach the switch to the rack using appropriate screws (not supplied).
7.
Connect the twisted pair cables from the end nodes to the RJ-45 ports on
the switch. When inserting an RJ-45 pug into a port, be sure the tab on the
plug clicks into position to ensure that it is properly seated.
Note
AT-8324SX Quick Install Guide
5
Advertisement
Table of Contents
